Keysight Technologies (Agilent HP) 8516A used or new for sale at Used-Line
SPECIAL OFFERS
Request Cart (0)
Watchlist (0)
Watchlist (0)

Showing Results for Keysight Technologies (Agilent HP) 8516A

9 results found for Agilent hp 8516a
Showing page 1 of about 1 pages total.
Here you will find a large selection of new and used Keysight Technologies (Agilent HP) 8516A listed at special prices. Although some items match several categories, all of them are listed here, no matter what category or subcategory they have been placed in. You may sort the listings from $3145 to $1840 or in reverse. You also have the option of showing only ads that have been posted in the last 24 hours.

Keysight Technologies (Agilent HP) 8516A () Main Features and Specifications

Product Specs

  • Status Discontinued
  • Alternative E8363C PNA Series Microwave Network Analyzer, 10 MHz to 40 GHz, E8363B PNA Series

The HP 8516A is an S-parameter test set for the 8510B.

The 8516A test set has a dual port architecture, which develops a separate reference channel for each incident port. RF switching is done with a single built-in electronic switch. For active device measurements, the test sets include the ability to apply DC bias (external) to the test port center conductors. Also available are two 60 dB step attenuators, which allow control of the port 1 and port 2 signal levels.

The 8516A test set is coupler-based. Two alternate coupler configurations are available. The standard configuration is symmetrical and has identical dynamic range performance in both forward and reverse transmission measurements. The port 1 step attenuator allows reduction of the port 1 output power for forward measurements, and the port 2 attenuator allows reduction of the port 2 output power for reverse measurements.

With the Option 003 configuration, the port 2 coupler is reversed. For forward measurements, the port 2 signal is sampled directly through the main arm of the port 2 coupler. Since coupling loss is removed, dynamic range is increased in the forward direction. Since the port 2 step attenuator is inline with the port 2 sample, the power incident on port 2 may be reduced. With Option 003, up to 1 W may be input into port 2.

  • Frequency range: 45 MHz to 40 GHz
  • Attenuation range: 0 to 60 dB
  • Impedance: 50 Ω, nominal
  • DC bias: 500 mA, 40 Vdc maximum
  • Connector type: 2.4 mm (M)
  • 8510B multiple test set configurations
    • IF switching (Option 001 required in one of the test sets): The 20 MHz IF signal is daisy-chained from the test sets to the 8510
    • RF switching: The RF signal must be routed to the desired test set using a 33311C coaxial RF switch and a 11713A switch driver. The switch driver is controlled automatically by the 8510B over the 8510 system interface.
  • Options
    • Option 001: Add IF switching
    • Option 002: Delete step attenuators and bias tees
    • Option 003: High forward dynamic range