Showing Results for Tektronix P6248

The P6248, P6247 and P6246 differential probes let users make time domain or frequency domain measurements on high bandwidth signals commonly found in disk drive, digital IC design (RAMBUS) and communication applications (Gigabit Ethernet, IEEE-1394 Firewire and Fibre Channel). The P6248 includes accessories that allow RAMBUS via probing and IEEE-1394 interconnect access. The small probe head geometry and assorted probe tip accessories allow these probes to easily accommodate manual probing of surface mount devices while maintaining high CMRR.

The P6246, P6247 and P6248 are ideal for design verification of disk drive read channel electronics and timing analysis for troubleshooting ground bounce problems associated with high speed logic. They can also be used for pulse shape or cross talk compliance testing of high speed communication signals.

• 1.7 GHz (Typical Probe Only ≤27 °C) 1X Mode
• 1.5 GHz Bandwidth (Guaranteed)
• 1.85 GHz (Typical Probe Only ≤27 °C) 10X Mode
• For Use with Oscilloscopes, Spectrum or Network Analyzers
• Low Input Capacitance: <1 pF Differential
• Probe Input Connector: Two Standard 0.025 inch/0.63 mm (0.1 inch center) Square Pin Receptacle (Female)
• Electrostatic Discharge Tolerant (IEC 801-2)
• Rise Time (specified): <265 ps
• DC Attenuation Accuracy: ±2%
• Common Input Voltage Range - ±7.0 V, 1X; ±7.0 V, 10X
• Differential Input Voltage Range - ±850 mV, 1X; ±8.5 V, 10X
• Maximum Nondestruct Input Voltage: ±25 V (DC + peak AC)
• Electrostatic Immunity: >15 kV
• Linearity: ±2%
• Noise: <50 nV/squareroot Hz
• Harmonic Distortion: ≤1.5%
• Passband Ripple: <±0.25 dB
• TEKPROBE Interface - Probe power, auto-scaling, auto-termination with TDS scopes
• Connects to TEKPROBE™ BNC Interface on TDS Series Oscilloscopes or Other Instruments Using 1103 TEKPROBE® Power Supply
• >60 dB (1000:1) Common Mode Rejection Ratio (CMRR)
• Small Probe Head Allows Easy Probing of SMDs