National Instruments PXI-2575

National Instruments PXI-2575 PXI Multiplexer Switch Module

The PXI-2575 (Part Number: 778572-75) is a high density PXI Multiplexer Switch Module that is perfect for a huge variety of channel robotized test applications. This module utilizes electromechanical relays and can direct many signals to measurement instruments or from source units. The PXI-2575 has an inward relay count to control relays and deterministic activity with equipment triggers to enhance test results. This module has several topologies available and can be configured as a 1-wire 196 x 1 multiplexer, a 2-wire, 95 x 1 multiplexer, or a 2-wire 98 x 1 multiplexer. The NI PXI-2575 uses socketed relays, which are simple to replace when they fail. The electrical life of the relays is approximately 105 operations when switching at the rated load. The device has a switch bandwidth of 20 MHz, a maximum switching power of 60 W, 62.5 VA (DC to 60 Hz) per channel.

This PXI Multiplexer Switch Module has a relay count tracking feature, which counts relay closures on all the independent relays. Relay counts are incremented every time a relay is activated. The counts are saved on the module and can be retrieved programmatically. This helps with predictive maintenance and minimizes unanticipated system downtime. Additionally, the device is equipped with a 200 POS LFH Matrix 50 I/O connector.

The NI PXI-2575 module is not suggested for 2-wire resistance measurements. The typical relay operating time is 1 ms, while the maximum relay operating time is 3.4 ms. The relay contact material is silver, gold covered, and the scan rate is 140 cycles per second. This PXI Multiplexer Switch Module can be used with NI-SWITCH and NI-DAQmx driver software. The device can be programmed using software packages/application development environments (ADEs) such as Measurement Studio for Visual C++, NI Switch Executive, LabWindows/CVI, and LabVIEW. This module can also be used with two cable types: the 1 m SH200LFH-4xDB50F-S: LFH200 to 50-pin D-SUB Switch Cable (CH-CH Twisted) or the 2 m SH200LFH- BAREWIRE: LFH200 Connector to Bare Wire Switch Cable. The device weighs 8.1 oz., and measures 8.5 x 0.8 x 5.1 in. in physical dimensions. It has a recommended operating temperature range of 0 °C to 55 °C.