Ismatec MCP

ISMATEC MCP Standard Peristaltic Programmable Pump w WARRANTY

This is a Good Working Ismatec MCP Programmable Peristaltic Dispensing Pump with 4 Channel Head (ISM 404). Actual Item Pictured. Unit Comes as Pictured with ISM-404 8 Roller Head, 4 Cassettes, Tubing, In/Out Manifolds For One Line in, Four Lines Out or Reverse (Can Use Without if Desired) User's Manual, and Power Cord. Unit will be Guaranteed for 30 Days Allowing Enough Time for Your Lab To Fully Test and Inspect.

Specifications:

• Flow rates < 0.001- 3700 ml/min (depending on mounted pump-head)
• Channels: 4 (depending on mounted pump-head)
• Operating panel: 7 button membrane key-pad, LED display
• Memory: 4 sets of operating parameters can be stored
• Operating modes- pumping by drive speed (rpm)

1. pumping by flow rate (ml/min)
2. factory-set flow rates for all available tube sizes
3. dispensing by volume (ml)
4. dispensing by time (0.1s up to 999hrs)
5. dispensing by volume within a pre-set time
6. interval dispensing by volume with a pause
7. interval dispensing by time with a pause
8. setting the number of dispensing cycles
9. pause time setting (from 0.1s up to 999hrs)
10. roller back-steps for drip-free dispensing
11. reversible rotation direction

• Calibrating function

1. for flow rate (ml/min)
2. for dispensing volume (ml)

• Speed: 1 - 240 rpm, resolution 0.1 rpm
• Speed control: closed loop control for pressure independent speed
• RS232 interfaces- RS232 "in" for operation controlling via PC
• RS232 "out" for cascading up to 8 pumps
• Analog input Speed control (0-5 or 0-10V / 0-20 or 4-20mA)
• Analog output Speed monitoring (0-10VDC or 0-12 kHz)
• Digital input: Start/Stop, rotation direction, autostart
• Differential pressure: 1.5 bar (21.7 psi) possible (depending on pump-head and tubing material); small tubing diameters may allow higher pressures
• Motor typeDC motor
• Power consumption100 W
• Powe: 115/230VAC 50/60Hz

Specifications